Smok RPM RBA - Single Coil RBA System

The Smok RPM RBA is a rebuildable Single Coil deck for DIYers to experiment with and build their own coils on. It comes with a pre-built 0.6 Ohm coil that can be wicked and re-wicked several times with cotton.

The Smok RPM RBA has one raised post that makes the most out of the limited space on the build deck. There’s plenty of threading on the tiny screws to give you the right amount of tension. The RBA comes with a Phillips head screwdriver to make working the screws easier.

Despite the small stature of the screws, they are relatively easy to work with. You will also find a sizeable inlet port on the deck that will allow air to come in directly beneath the coil. Having the inlet centrally above the coil ensures excellent delivery.

The RBA is perfect for both DL and MTL vapers. For MTL vapers, there’s a plug that comes inside the package that you can use to limit the airflow for an MTL draw. For DL vapers, you can do without the plug.

The Smok RPM RBA is an excellent choice for vapers that are just starting to work with rebuildable atomizers because of its simple design. Experienced vapers will find the performance and experience of the atomizer exceed expectations.

The Smok RPM RBA is compatible with the following Smok kits:

Nord 50W kit (Nord 50W empty RPM pod)
RPM 4 kit (RPM 4 RPM pod)
IPX 80 kit (IPX80 RPM pod)
Nord 4 Kit (Nord 4 RPM Pod),
Thallo & Thallo S Kit (Thallo Empty RPM Pod),
Nord X Kit (Nord X Empty RPM Pod),
RPM 2 Kit & RPM 2S Kit (RPM 2 Empty RPM Pod),
SCAR-P3 Kit (SCAR-P3 Empty RPM Pod),
SCAR-P5 Kit (SCAR-P5 Empty RPM Pod),
RPM Lite Kit,
Alike Kit (Alike Empty RPM Pod),
Pozz X Kit (Pozz X RPM Pod)
Nord 2 Kit (Nord 2 RPM Pod),
Fetch Pro Kit (Fetch Pro RPM Pod),
RPM80 Kit & RPM80 pro Kit (RPM80 RPM Pod),
Fetch Mini Kit (Fetch Mini Empty RPM Pod),
RPM40 Kit (RPM Standard Pod)
Morph pod-40 kit
Stick R22 kit

Smok RPM RBA Features:

Sub Ohm Rebuildable Coil

Nichrome Construction

Coil Wire Pre-Installed

0.6 Ohm Resistance

Suited To High VG E-Liquids

What's in the box:

Smok RPM RBA

Pre-made Coil 0.6 Ohm installed on deck

Cotton

Screwdriver

4 x Replacement Screw

4 x Spare o-rings

How To Build The RPM RBA?

1.Make sure your hands are clean.

2.Take RBA deck apart.

3. Installing and positioning the pre-built coil, place the coil between the posts and wrap the ends around the screws and tighten up, once all in place make sure the coil is fixed in the centre and lined up with the air hole, and also make sure the coil is not touching the base.

4. Cutting the end of the wire off.

5. Cutting a strip of cotton and make sure it’s not too much and not too less.

6. Inserting the cotton and placing it in the middle.

7. Cutting the cotton at an angle and make sure it’s not too short and not too long.

8. Wet the coil with your e-liquid and adjust the cotton.

Note: the resistance of the pre-built coil must be checked before installing on the RBA deck, and re-checked periodically to ensure the resistance remains the same. The RPM RBA only supports the resistance of coils over 0.25ohm.